MP3 Players & iPods, Electronics. To change the battery in an iPod Classic first set it on a flat surface face up. Make sure the unit is powered off. Please continue on to the final page of this article to learn how to change the battery in an iPod Touch and iPod Shuffle.
Pot player is a common media player software which is used widely due to its ability to play various types of media files seamlessly. With Pot Player, there is No need to install different codecs all the time when using the player because the player Supports OpenCodec so users can easily add whatever...
If the computer enters a power saving mode while the player is connected via the USB cable, such as the Sleep or Hibernation mode, the battery will not be charged. Instead, the player will continue to draw power from the battery, discharging it. Make sure the USB cable is plugged into the player and the computer securely.
But this technology promises features I think are worth paying for, just like having Li-Ion and Li-Polymer batteries in your cellphone, mp3 player, and PDA right now. Imagine when the battery for your cellphone or iPod is long-lived enough to be printed onto the circuit board and never replaced, and it can receive a charge in only a few seconds.
Suddenly, our player started making this cranking noise, even when our van engine is off and the key is out of the ignition. It just keeps cranking unless we unplug the battery. After unplugging the battery it runs quietly for a few days and then starts cranking again (it sounds like the player is trying to spit out the disc inside). Any thoughts?
I was desperate for a new MP3 player and spent a long time choosing. I like it a lot, the battery life is good, the sound quality is good (using my own earphones, not the ones supplied) and if you take the time to set up folders the navigation is fine.
Connect the iPod and click the iPod button. After connecting the iPod, iTunes adds the iPod button in the upper-right corner of the window, which includes the eject button on the right side, and either the X cancel button to cancel syncing (move your pointer over the animated sync icon to see the X if the iPod is syncing) or an iPod icon on the right side.
Step 1 - Disconnect the battery. Disconnect the negative cable of the battery and remove the rubber pad on top of the radio trim panel with two 9/32” screws. Figure 1. Removing the negative cable. Step 2 - Remove the stereo trim. Take the A/C vent side panels off from the radio trim and slowly remove the stereo radio trim, including the molex plugs.